image

Cap, Two Piece (Flask)

Model Number SS-3014

$16.72
  • Item Description
  • Specifications
  • Includes a two piece cap for one 300 ml flask. Filter linings sold separately.
  • Available in four convenient colors: red, blue, green, and yellow.

The TUNAIR™ two piece cap assemblies are constructed of polypropylene and are resistant to most solvents. All flasks and caps are fully autoclavable prior to reuse and filter linings can also be autoclaved or simply replaced. To replace the filter lining in the cap assembly, simply pinch the flanges of the inner-closure shell until they snap loose. Then, pull apart and remove used lining. Replace the lining by sandwiching it between two parts of the cap and snap the cap back together. When reassembling the cap, ensure the flanges from the inner piece snap into the mated grooves in the outer piece. This will ensure the cap assembly stays together during use.

All TUNAIR™ caps can be cleaned by soaking in water with a light detergent solution to loosen dirt and contaminants, then air dry.

Material:
All TUNAIR Erlenmeyer flasks and caps are constructed of chemical resistant polypropylene. All flasks and caps are fully autoclavable.

Cleaning:

Your TUNAIR flasks are constructed of polypropylene plastic which allows them to be autoclaved. Once you have prepared your media inside the flask you can place the cap & filter on the flask and insert into the autoclave. Set the autoclave for wet cycle.   

Once you have harvested your cells, wash the TUNAIR flask in a mild dish soap such as Dove Dish Soap then rinse well with DI water. Do NOT rinse the Dri-Gauze filter between uses. The silicone filter can also be rinsed with DI water if needed. Observe the condition of the filters between runs to make certain there are no holes or tears in the filter. If there are, replace the filter immediately.

All TUNAIR Erlenmeyer flasks and caps can be cleaned by soaking in water with a light detergent (i.e. Joy) solution to loosen dirt and contaminants; air dry. All TUNAIR flasks and caps can be autoclaved, if required.

Two Piece Cap: 

The 300 ml flask and 2.5 L flask both have a special cap and filter system that promotes gas exchange and maintains sterility of the growth culture during use. The inner portion of the cap unsnaps from the outer portion by pushing in the tabs on the side of the cap assembly and then pulling the insert out.

0.2 micron filters: 

There are two different types of 0.2 micron filters available for the TUNAIR flasks. These filters allow for maximum gas exchange while maintaining sterility.

Dri-Gauze:

This is a paper filter than can be used approx. 6 to 8 times before having to be replaced. This filter can be autoclaved while in the cap, on the flask, for 6 to 8 times.

Silicone: 

This is a silicone filter that will last the life of the flask. This filter can be autoclaved while in the cap and on the flask for many times.

 

Cap & Filter assembly: 

Once you have the 2-piece cap assembly apart (either the 300 ml cap or the 2.5 L cap) place the corresponding filter size inside the cap and the re-assemble the inner and outer cap pieces making certain to align the tabs with their associated holes. Once clipped into place, make certain the filter completely covers the cap assembly openings. 

25% off your order

Enter your email address to get 25% off your order and free shipping today

image